Avenger TBM-3W Warner AEW in 1/32 scale
Dutch Naval Air Arm (Marine Luchtvaart Dienst MLD)
....continueing from page 2...
The blue is a colour that needs several
coats to get a good result, so I decided to already at this stage apply
a couple of coats with the Steinbeck airbrush, using
Xtracolour X121 enamel for the FS25042.
The cockpit area was masked off to
(The rear hump proved to be a difficult spot as I had some trouble with the curing of the resin. I had to install a new resin part, which caused delay in finishing my model).
After the coats dried up, this revealed that additional minor filling is still necessary. This will be done next, with again some blue coats to be added.
On to next
[ Page 4 ...]
Back to 1/32 scale Models.......
(c) Copyright Meindert "designer"/ All rights reserved. Your comments are welcomed by webmaster
|Created this page November 20, 2009|