STEP 14
Wait with the basic fuselage assembly......

As the model was to be finished in the kit scheme of white and red, it was decided to take a somewhat different approach as to painting. See later on...

STEPs 15-23
The wing and tailplane was sub-assembled as they also would get a pre-painted white base coat. The same was done for the separate flaps and the intake parts from STEPs 25-26.
Some filler was needed, such as on the leading edge and the wheels (from STEPs 29-30).

EXTRA detail?
It was also decided to add a little more detail to the model through a detailed avionics and equipment bay. From walkaround photos a very nice opened up bay was seen. A bay will will be displayed on the lower right fuselage side. With a TIGER razor saw, the panels were cut away from the fuselage half (part #A2).

Work in progress above....

A dry-fit check was done if all would fit...

STEP 27
The open gaps on the lower fuselage part #F1 are OK, but inside some card was added to prevent see through inside too much. 

All smaller intake scoops were added to each fuselage half. Fitting the exhaust fairing parts #C1 and #C19 required a bit filler and sanding. 

One of the intakes from STEP 9 was fitted as well to the left fuselage half.

STEPs 33-34
The wing tips tank were also assembled. Do NOT yet fit to the wing tips though.